Filter
Top Products
Programmable Settings
22
Line Mode
If the line is connected to a low voltage system such as a PBX, set to “B”
using either the base unit or handset. Your phone comes from the factory
set to “A”.
With the base unit
Make sure the base unit is not being used.
1
Press (FUNCTION).
2
Scroll to “Initial setting” by pressing
Ö or Ñ, and press á.
3
Scroll to “Set tel line” by pressing Ö
or Ñ, and press á.
4
Scroll to “Set line mode” by pressing Ö
or Ñ, and press á.
5
Press Ö (Line 1) or Ñ (Line 2) to select
the line.
•The line’s current setting will be displayed.
6
Select “B” or “A” by pressing Ö or Ñ.
7
Press á (Save).
•A beep sounds.
•To program the other line, start again from step 4.
•To exit the programming mode, press (STOP/EXIT).
•You can exit the programming mode any time by pressing (STOP/EXIT)
.
With the handset
Make sure the base unit and the handset are not being used.
Press (CONF/FUNCTION), and follow steps 2 to 5
of the base unit, using the handset. The display
will then show the following.
Select “B” or “A” by pressing Ö or Ñ, and press
the right soft key ( ).
•You can exit the programming mode any time by pressing (OFF).
SAVE
Set line mode
Line1 :A
GF
SAVE
Set flash time
H
Set line mode
---------------
Caller ID edit
H
Set tel line
Set answering
Copy directory
H
Initial setting
---------------
Set line mode
G
=Line1
F
=Line2
Set line mode
Line1 :A
GF
H
=Save
---------------
H
Save directory
Ringer setting
LINE1 LINE2