Filter
Top Products
Preparing the Answering System
30
Number of Rings
You can select the number of times the unit rings before the Answering
System answers a call, from “2” to “7” or “Toll saver”*.
Your phone comes from the factory set to “4”.
Use the base unit. Make sure the base unit is not being used.
1
Press (FUNCTION).
2
Scroll to “Initial setting” by pressing
Ö or Ñ, and press á.
3
Scroll to “Set answering” by pressing Ö
or Ñ, and press á.
4
Scroll to “Number of rings” by pressing
Ö or Ñ, and press á.
5
Press Ö (Line 1) or Ñ (Line 2) to select
the line.
•The line’s current setting will be displayed.
6
Select the number of rings by pressing Ö
or Ñ.
•You can also select the number of rings by
pressing (0) (Toll saver*), or (2) to (7).
7
Press á (Save).
•A beep sounds.
•To program the other line, start again from step 4.
•To exit the programming mode, press (STOP/EXIT).
•You can exit the programming mode any time by pressing (STOP/EXIT)
.
*Toll saver
When you call a line to which “Toll saver” is set, from outside:
If the unit answers on the 2nd ring, there is at least one new message.
If the unit answers on the 4th ring, there are no new messages.
Hang up when you hear the 3rd ring. This will save you the toll
charge for the call.
Greeting check
H
Number of rings
Recording time
Copy directory
H
Initial setting
---------------
Set tel line
H
Set answering
---------------
Number of rings
Line1:4
GF
H
=Save
Number of rings
G
=Line1
F
=Line2