July 2006 Installing the 201i server in an Option 11C or Option 11C Mini
201i Server Hardware Installation 87
See the following diagram:
3 Refasten the inner SCSI bracket screws in their original locations inside
the cabinet.
You will use the top screw later to fasten the NTRH3502 SCSI cable drain
wire.
4 Connect the low-profile right-angle SCSI connector on the NTRH3502
cable to the SCSI connector on the 201i server faceplate.
5 Fasten the SCSI cable drain wire to the top screw that previously held the
inner SCSI bracket in place.
G101587
Inner SCSI
bracket
Note: After you remove the bracket, refasten the screws in their original locations
inside the cabinet.