Filter
Top Products
July 2006 Connecting peripheral devices to the 201i server
201i Server Hardware Installation 151
Connecting the 201i server to the switch,
ELAN, and CLAN
Introduction
The CLAN and ELAN connections are established by using the 201i server
multi I/O cable.
To establish the switch and network connections
1 Do one of the following:
ATTENTION
For important considerations about using the Embedded
LAN (ELAN) in your network, see “About the ELAN”
in the CallPilot Installation and Configuration Task List.
IF you are installing the
201i server in a THEN
large Meridian 1
(for example,
Option 51C)
ensure that the 50-pin amphenol connector
on the multi I/O cable (NTRH0912) is
connected to the newly installed backplane
cable (NTRH3501) on the I/O panel at the
rear of the switch.
Option 11C connect the 50-pin amphenol connector on
the multi I/O cable (NTRH0912) to the
high-density connector associated with the
left slot occupied by the 201i server.