Filter
Top Products
July 2006 Connecting peripheral devices to the 201i server
201i Server Hardware Installation 145
that is not described in this guide, ensure that you use appropriate
cabling for each SCSI device.
5 Connect the power cord for each device.
6 Power up the devices.
7 Continue with “What’s next?” on page 150.
To connect the CD-ROM and tape drives to the
201i server (Option 11C)
1 Connect the first SCSI device.
2 Follow instructions below:
3 Connect the low-profile right-angle SCSI cable connector to the SCSI
connector on the 201i server faceplate.
4 Connect an additional device in a daisy chain, if required, using either the
SCSI cable supplied with the device or an NTRH3502 cable.
IF the first
device is the THEN
CD-ROM drive connect the NTRH3502 SCSI cable from the
CD-ROM drive to the SCSI connector that is
located on the intermediate SCSI cable bracket
assembly (NTRH1407) on the Option 11C.
tape drive do the following:
a. Attach the A0769312 SCSI adapter to the tape
drive.
b. Connect the NTRH3502 SCSI cable from the
adapter to the SCSI connector that is located on
the intermediate SCSI cable bracket assembly
(NTRH1407) on the Option 11C.