Filter
Top Products
Installing the 201i server in the Succession 1000 system Standard 1.03
104 CallPilot
2 Remove the inside front cover plate as follows:
a. Use a screwdriver to loosen each screw on the top of the inside front
cover plate by three turns.
b. Apply pressure and slide the inside front cover plate upward to the left
until the screw holes are aligned with the screw heads.
c. Pull the inside front cover plate away from the Media Gateway or
Media Gateway Expansion.
What’s next?
Continue with “Installing the 201i server” on page 105.
ATTENTION
Do not remove the screws.
G101621
A
C B