Filter
Top Products
July 2006 Installing the 201i server in the Succession 1000 system
201i Server Hardware Installation 109
Note: Alternate connection scenarios are supported, but are not depicted in
this guide. If you want to use a connection scenario that is not described in
this guide, ensure that you use appropriate cabling for each device.
Before you begin
1. Before you install the SCSI devices in a daisy chain, you must configure
the SCSI device IDs and DIP switches. For instructions, see “Preparing
peripheral devices,” on page 119.
To install the NTRH3502 cable
1 Remove the inner SCSI bracket from the inside of the Media Gateway or
Media Gateway Expansion.
See the diagram on page 110.
.
CAUTION
Risk of equipment damage
You must power off the 201i server before connecting or
disconnecting SCSI cables.