Filter
Top Products
Connecting peripheral devices to the 201i server Standard 1.03
154 CallPilot
Connecting the modem
Introduction
You must connect the modem to the 201i server if:
you want to administer the 201i server from a remote location.
you need assistance from Nortel technical support.
Required equipment
To install the modem, you need the following items:
analog external modem that includes
RJ-11 analog phone cord
power adapter cord
56 kbps modem (NTRH9078)
25-pin male to 9-pin female shielded serial cable (A0601464)
two 0.25-inch nuts for installation between the following:
RS-232 connector thumbscrews on the multi I/O cable; maximum
length 15 m (50 ft)
9-pin connector thumbscrews on the 25-pin male to 9-pin female
shielded serial cable
analog line jack
To connect the modem
1 Ensure that the DIP switches are set as described in “Setting the modem
DIP switches” on page 122.