Filter
Top Products
Connecting peripheral devices to the 201i server Standard 1.03
144 CallPilot
3 Connect the low-profile right-angle SCSI cable connector to the SCSI
connector on the 201i server faceplate.
4 Connect an additional device in a daisy chain, if required, using either the
SCSI cable supplied with the device or an NTRH3502 cable.
The following diagram shows cable connections, where the CD-ROM is
the first device:
Note: Alternate SCSI device connection scenarios are supported, but
are not depicted in this guide. If you want to use a connection scenario
tape drive do the following:
a. Attach the A0769312 SCSI adapter to the
tape drive.
b. Connect the SCSI adapter to the
NTRH1410 cable that you connected earlier
to the Meridian 1 I/O panel.
IF the first device is the THEN
Meridian 1
201i cabling Peripheral cabling
201i
NTRH30AA
Optional
NTRH9038
Tape drive
NTRH9105
CD-ROM
drive
G101430
SCSI device cable
NTRH3502
Rear
I/O panel
NTRH1408
NTRH1410