Filter
Top Products
July 2006 Installing the 201i server in the Succession 1000 system
201i Server Hardware Installation 103
a. Use a slot screwdriver to gently pry off the SUCCESSION label.
b. Insert the screwdriver approximately 2 cm (0.75 in.) into the open slot,
and then gently lift the screwdriver handle, thus applying downward
pressure on the tab inside the bezel.
At the same time, gently pull the bezel away from the chassis
(approximately 2 cm [0.75 in.]) until the inside tab has cleared the
catch.
c. Grasp the bezel by both sides and carefully pull it straight away from
the Media Gateway or Media Gateway Expansion.
G101620
B
C
A