Filter
Top Products
July 2006 Installing the 201i server in the Succession 1000 system
201i Server Hardware Installation 115
Connecting cables to the Succession 1000
system
Introduction
The following items are connected to the back of the Media Gateway or
Media Gateway Expansion:
multi I/O cable (NTRH0912)
This cable establishes the connection to the modem, ELAN, and CLAN.
Media Gateway or Media Gateway Expansion power cord with two
ferrites
You must connect the multi I/O cable first before connecting the power cord,
because the power cord routes above the multi I/O cable connection.
To connect the cables
1 On the rear of the Media Gateway or Media Gateway Expansion, locate
the connector associated with the first slot occupied by the 201i server.
2 Connect the NTRH0912 multi I/O cable as follows:
a. Loosen the connector’s Velcro fastening strap.
b. Connect the amphenol connector on the NTRH0912 multi I/O cable to
the connector on the back of the Media Gateway or Media Gateway
Expansion.