Responsible party
(North America) (Europe)
Handspring, Inc. John Hartnett
189 Bernardo Avenue VP Worldwide Operations
Mountain View, CA 94043 Handspring
United States of America 89 rue de Lyon
www.handspring.com 1203 Geneva, Switzerland
Antenna Care/Unauthorized Modifications Use only the supplied
integral antenna. Unauthorized antenna modifications or attachments
could damage the unit and may violate FCC regulations. Any changes
or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Declaration of Conformity
Treo Model 600 Handspring declares that the above models of Treo
communicators are compliant with the regulations below. The declaration
applies to the communicators and their associated accessories (power
supply, headset, USB and serial cable) where applicable.
Maximum Measured SAR Values (W/kg)
Band: 850 MHz 900 MHz 1800 MHz 1900 MHz
Head SAR: 1.49 1.07 1.53 1.05
Body SAR: .646 .703 .402 .336
EMC: EN 301 489
GSM: EN 301 419-1(Apr 2000)
EN 310 420 (Dec 1999)
SAR: ANSI/IEEE C95.1 1992
EN 50360 (July 2001)
EN 50361 (July 2001)
FCC OET Bulletin 65 Supplement C
Safety: EN 60950: 2000 (Jan-2000)
Radiated Emissions: EN 55022
Immunity: EN 55024
Using TTY
A TTY (also known as TDD or Text Telephone) is a telecommunications
device that allows people who are deaf or hard of hearing, or who have
speech or language disabilities, to communicate by telephone.
Your Treo 600 is compatible with select TTY devices. You can
connect a TTY/TDD machine to your phone through the headset
jack, but you cannot use your headset jack with a headset or
handsfree kit, while this mode is enabled. Please check with the
manufacturer of your TTY device for connectivity information and to
ensure that the TTY device supports digital wireless transmission.
To use TTY, you may need to make additional arrangements with
your mobile service provider. Please contact their customer service
department for more information.
1. Press Phone.
2. Dial #*889, and choose Dial.
3. You will receive an onscreen alert that TTY is enabled.
4. To disable TTY, dial #*889 again, and choose Dial. A red “T” will
appear at the top of the Phone screen whenever TTY is enabled.
FCC Statement This device complies with part 15 of the FCC
rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
•Increase the separation between the equipment and receiver
• Connect the equipment into an outlet or circuit different from that
to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
and for additional suggestions.
RF Safety Exposure To Radio Frequency Energy (SAR) Radio
transmitting devices radiate Radio Frequency (RF) energy during its
operation. RF energy can be absorbed into the human body and
potentially can cause adverse health effects if excessive levels are
absorbed. The unit of measurement for human exposure to RF
energy is “Specific Absorption Rate” (SAR).
The Federal Communications Commission (FCC), Industrie
Canada (IC), and other agencies around the world have established
limits that incorporate a substantial safety margin designed to
assure the safety of all persons using this equipment.
In order to certify this unit for sale in the US, Canada and Europe
this unit has been tested for RF exposure compliance at a qualified
test laboratory and found to comply with the regulations regarding
exposure to RF Energy.
SAR was measured with the unit transmitting at its maximum
certified RF power. Often, however, during normal operation the unit
will transmit much less than maximum power. Transmit power is
controlled automatically and, in general is reduced as you get closer
to a cellular base station. This reduction in transmit power will result
in a lower RF energy exposure and resulting SAR value.
FCC RF Safety Statement In order to comply with FCC RF
exposure safety guidelines, users MUST use one of the following
types of body-worn accessories.
1. A Handspring brand body-worn accessory that has been tested
for SAR compliance and is intended for use with this product.
2. An accessory that contains NO metal (snaps, clips, etc) and provides
AT LEAST 1 cm of separation between the users body and the unit.
Do NOT use the device in a manner such that it is in direct contact
with the body (i.e. on the lap or in a breast pocket). Such use will likely
exceed FCC RF safety exposure limits See www.fcc.gov/oet/rfsafety/
for more information on RF exposure safety.
150 :: FCC