Filter
Top Products
$ GGLQJD1HZ'LVSOD\8QLW
BusinessPhone Call Centre Supervisor - Standard
Installation Guide
EN/LZT BS 102 063/S R2B
47
%DXG5DWH
If adding a physical Display Unit you must set the Baud Rate for the transfer be-
tween the PC and the new unit. The Baud Rate list shows all the supported Baud
Rates for the type of Display Unit selected. The default rate will be highlighted.
Select the required rate.
If you enter a Baud Rate that is different from the Baud Rates of Display Units
already configured on the selected Comm Device, a warning dialog will be dis-
played and you will be given the opportunity to either choose the existing Baud
Rate or to set the rate for all Display Units on the Comm Device to the same new
rate.
$GGUHVV
All Display Units must have an address which is unique for the COM or GUI de-
vice they are connected to. Enter an address in the Address field. When adding
physical Display Units, the address entered must match the actual setting of the
Display Unit itself.
If you enter an Address that is already used by Display Units already configured
on the selected Comm Device, a warning dialog is displayed and an unused ad-
dress is entered in the Address field for you to accept.
&KDQJLQJ&RQQHFWLRQ3DUDPHWHUV
At times it may be necessary to alter certain connection parameters. Changing
connection parameters is carried out via the Edit Display Unit Configuration di-
alog which is accessed by highlighting the Display Unit to be edited in the grid
and clicking the Edit button.
The Edit Display Unit Configuration dialog is similar to the New Display Unit
Configuration dialog and enables you to edit Display Unit parameters. Remem-
ber, however, that a Display Unit name cannot be edited once a Display Unit has
been added.