Filter
Top Products
3RVW,QVWDOODWLRQ&RQILJXUDWLRQ
BusinessPhone Call Centre Supervisor - Standard
Installation Guide
EN/LZT BS 102 063/S R2B
31
To change an Alias:
Select the required Alias in the list
Change the Alias parameters as required
Example
For Example, if the installation of the CCS was done to a drive other than the C:\
drive but the default CCS directory was retained.
You must replace the ? in the alias with the cho-
sen drive letter and the directory name the CCS
was installed into, for example D:\CCS\DA-
TA\CONFIG.
If you used another directory name, such as
C:\MIS then you would have to set the same
alias to c:\mis\data\config.
Important
It is extremely important to be careful when changing aliases, as any mis-
take will cause the CCS to fail.
3DUDGR['ULYHU
If necessary you will be required to set the Paradox Driver NETDIR parameter
to match the drive that the driver is installed to.
To set the NETDIR Parameter:
Open the Drivers page
Select the PARADOX driver in the Driver Names list
Set the NETDIR parameter to the correct drive