Filter
Top Products
PBX Networking Connections
93
9.1.1 Connection via Q.SIG-IP
If you are operating a fast and continuous internet connection at two or more
locations, you can establish the TK system networking via internet connection. The
Aastra 800 uses the Q.SIG protocol, for use with ISDN point-to-point connections
and transports the protocol and voice data via IP connections.
The number of simultaneous conversations possible will depend on the capacity
of the internet connection and the compression method used. A multiple S
2M
point-to-point connection is simulated for each Q.SIG-IP bundle. This means that 5
virtual D channels and up to 120 voice channels are available. The Media Gateway
software function is used for Q.SIG-IP.
Q.SIG-IP connection data are subject to codec compression (please refer to Voice
over IP (VoIP) chapter regarding Fundamentals starting on page 62). Q.SIG-IP also
transfers the voice data directly from terminal to terminal via the RTP protocol. In
certain cases, for example, when an incoming external call is placed via multiple TK
systems, one or more RTP proxies may be used to forward the connection.
Currently, there are no standards for the necessary extensions to the Q.SIG pro-
tocol. This means that you can only use Q.SIG-IP between Aastra 800 systems.
Networking two Aastra 800 systems using Q.SIG-IP requires 2 licenses – one
license per system. The number of possible voice connections is not restricted by
the license.
Go to the Telephony: Trunks: Bundle page in the Configurator to set up a Q.SIG-
IP connection. Create a new bundle and select the Access type “System Access”.
Select “Q.SIG-IP” under Protocol. Configure the IP address of the other system, the
port numbers to be used, the number of possible voice connections and select a
VoIP profile for the codec selection. Please refer to the relevant help topics in the
Online Help for the Aastra 800 as well.
Note: Q.SIG-IP cannot be operated using a connection with
NAT. For a Q.SIG-IP connection, a branch connection or an-
other VPN connection is required.