Filter
Top Products
Features
Message Waiting
Strata DK Electronic Telephone 5/00 49
Message Waiting
All telephones have a standard MW/FL LED for receiving/retrieving messages left by
callers that called a [PDN] that was busy or did not answer. Telephones that own
[PhDNs] can also have up to four additional (flexible) message waiting [PhDN/MW]
buttons and LEDs. The fourth message waiting button is reserved for the Message
Center.
The MW/FL LED at the called station flashes to notify you that someone called while
you were busy on another call or away from your office. You can call the other party
back by pressing the
0:)/ button. Voice mail devices, as well as people, can leave
message waiting indications.
If you have an LCD telephone, up to four message waiting
displays may be stored on the LCD per each [DN]. The LCD
can show up to three stations that have left messages for your
[PDN] and three for each of your [PhDNs]. The fourth message waiting button is
reserved for the Message Center.
➤ To answer a Message Waiting on your [PDN]
2. Dial the number.
3. Press
68%. This informs the system that the following digits are
the subaddress.
4. Enter the subaddress.
5. Press
67$57. The dialed digits will not be sent until you press this
button or until the timer expires.
1. Press
0:)/ and lift
the handset.
Your phone rings the station or voice mail device that
set the indication. The LED continues to flash red.
If you reach a station that is busy or does not answer,
go on-hook and press
0:)/ again. The system
rotates to the next message sender.
NO. 204
CALL 203-201+