Filter
Top Products
DSS Console
Features
Strata DK Electronic Telephone 5/00 103
Features
The LED color indications described here apply to DSS Console models HDSS2060
and HDSS1060. Flash conditions described here apply to all DSS Console models.
Calling a Station
To call a station [PDN] from a DSS Console, press the [DSS] associated with the
station. A station call with a [DSS] button can be made on-hook or off-hook and with
Voice First or Tone signaling. After pressing the button, treat the call like any other
station call made from a electronic telephone.
[DSS] LEDs show if the associated station is idle or busy. The LED is steady red if the
station is busy or ringing, and is not lit if idle. If all the station’s PDN buttons are
being used by other stations, the [DSS] LED of the station lights steady red, but the
station may be idle. If the station is in the DND mode, its [DSS] LED lights steady
red.
Transferring a Call
You can transfer internal or outside calls to an idle station from a DSS Console. You
can transfer a call to a busy station from your DSS Console. Use [DSS] to transfer the
call, even though the [DSS] LED for the station you are transferring to is red.
➤ To transfer a call to an idle station
1. Press the [DSS]
button associated
with the called
station.
The call is automatically placed on hold. The CO or
[DN] LED flashes at double the on-hold rate, and the
[DSS] LED flashes.
You hear a single-ring tone. If using the tone signaling
mode, you hear successive ring tones.
2. Announce the call. With tone signaling, you have to wait for the called
station to answer before announcing the call.
3. Hang up. The call rings the called station when you hang up.
While the called station is ringing, the [DSS] LED is
steady red, and the CO LED flashes at the on-hold rate
or if on a [DN] button, it goes idle.