Filter
Top Products
Schedule Table
The Schedule Table determines when the SVMi-8 will automatically change Modes. A mode is a set of operating
rules for a specific situation, like day mode or night mode. These changes may be based on Port Number, Date or
Day of Week, and Time of Day. The Schedule Table contains one record for each scheduled change.
This selection of modes may be automatically set by this schedule table or manually overridden via a touch tone
phone, using the MANUAL MODE SELECTION function. When a call comes in, the schedule table is checked to find
out which mode rules to apply to the call.
If the entry says AUTO then the SVMi-8 will change between mode 1 (Day Mode) and Mode 2 (Night Mode) when-
ever the phone system changes between Day and Night operation.
The SVMi-8 selects a mode from this schedule based on an Order of Precedence. Schedule table entries which select
the mode based on port number take precedence over those based on date. Date takes precedence over Day of Week
(DOW), and time is at the bottom of the order.
Each entry defines a start time for the mode. The mode will continue until the start time for the next defined mode.
In the example screen shown, if an additional entry is made which selects Holiday Mode, when Date = 12/25, it will
take precedence over the other records. In other words, the SVMi-8 will switch to Holiday Mode on December 25,
regardless of what Day of Week, it happens to be.
The information contained within the Schedule Table screen shown in this section is for discussion and display pur-
poses only.
One page contains the Schedule Table parameters. The parameters are grouped by category as follows:
Mode Name Column This is the mode block which will start the application. To create a new mode, highlight a
blank line and press ENTER to bring up the Target Generator. Select a new or existing mode block and press ENTER.
The Mode Name column is automatically filled in. Fill in the rest of the line with the following information. To review
or edit an existing mode block in the Schedule Table, highlight the desired field and press 'Ctrl + O'.
System Main Menu
5
SScchheedduullee TTaabbllee
Page 1 of 1