Filter
Top Products
3. Position the Voice Mail card with solder side up, so that the holes in the card line up with the studs on the HDD
adapter.
4. Insert the 4 screws, and tighten until snug. DO NOT OVERTIGHTEN.
5. Replace the plastic cover (if the Voice Mail card is to be installed in a DCS or iDCS 500).
6. Replace the SVMi-8 in the phone system.
Installing or Removing a Compact Flash Adapter
Removing the Compact Flash (CF) Adapter
1. Power down the phone system and remove the SVMi-8 card.
2. Remove from plastic case (if the Voice Mail card has been removed from a DCS or iDCS 500).
3. Hold the unit with the CF Adapter supported in your hand, held by the edges. The solder side of the card should
be facing up.
4. Remove the 4 retaining screws so that the CF Adapter becomes detached.
5. Still holding the CF Adapter by the edges invert the card (component side up) and gently unplug the ribbon
cable.
6. Gently pack the CF Adapter in the SEC provided packaging.
Installing the Compact Flash (CF) Adapter
1. Hold the CF Adapter by the sides with the 4 screw studs facing up.
2. Attach the ribbon cable between the CF Adapter and the Voice Mail card. The 4 spare pins on one end of the
connector are not used.
3. Position the Voice Mail card with solder side up, so that the holes in the card line up with the studs on the CF
adapter.
4. Insert the 4 screws, and tighten until snug. DO NOT OVERTIGHTEN.
5. Replace the plastic cover (if Voice Mail card is to be installed in a DCS or iDCS 500).
6. Replace the SVMi-8 in the phone system.
Installing Individual SVMi-8 Components
7