Filter
Top Products
Message Notification and Delivery
The following programming parameters can be entered for Message Alert (being called at a designated number and
notified of new messages) or Pager (notification by beeper).
Port To Use The port used for notification. Enter specific port numbers (eg. 1,2,4) or a range (eg. 2-4).
Number of Attempts The number of attempts made to perform notification.
Busy Retry Time The time between notification outcall attempts, in minutes, if the previous attempt returned a busy
signal.
No Answer Retry Time The time between notification outcall attempts, in minutes, if the previous attempt returned
was not answered.
Callback Authorizations
Each subscriber may be allowed, to press a single key and return a call to the person who left a message. This is
called the Callback feature and is allowed denied or limited in this set of options.
On Premise Y/N Set to 'Y' to allow the subscriber to make on-premise Callbacks.
On Premise Station Type Station block type to use for on-premise call backs. Press ENTER to bring up the Target
Generator. Select a new or existing Station Block and press ENTER. Press ‘Ctrl + O’ to review or edit the selected
Block. Leave this field blank for SVMi-8 to auto select.
Off Premise Y/N Set to 'Y' to allow the subscriber to make off-premise Callbacks.
Off Premise Station Type Station block type to use for off-premise call backs. Press ENTER to bring up the Target
Generator. Select a new or existing Station Block and press ENTER. Press ‘Ctrl + O' to review or edit the selected
Block. Leave this field blank for SVMi-8 to auto select.
Long Distance Y/N Set to 'Y' to allow the subscriber to make long-distance Callbacks.
Block Types and Descriptions
70
MMCCllaassss BBlloocckk
Page 2 of 4