Filter
Top Products
Feature Reference
5-232
Restore Programming (#125)
Description
This System Programming procedure enables you to reinstate your system and
telephone programming (except the System Day, System Date, and System
Time) to the settings saved on a PC Card at the last system backup (manual or
automatic). This procedure is useful if your system settings become corrupted, if
you make changes and decide you would rather use the former settings, or if you
replace your processor module and want to retain the system settings you had on
the previous processor module. A successful restore takes about five seconds.
NOTE:
When a restore completes successfully, the Restore Complete message
displays for two seconds at idle extensions 10 and 11, and then a System
Reset—Programming Saved (#728) occurs,
disconnecting any calls in
progress
. It is recommended that you warn users before beginning a
restore, or do the restore during nonbusiness hours.
Related Features
■ Backup Programming—Automatic (#123) automatically saves your
programmed settings at regular intervals.
■ Backup Programming—Manual (#124) is a manual procedure that you
can perform at any time to back up your system and telephone
programming settings.
■ System Reset—Programming Saved (#728) automatically occurs
following a successful restore. The reset disconnects any calls in progress.
Considerations
■ If the restore is not successful, the display shows
Restore Failed
or
Restore Failed-Try Again
for two seconds. All calls that were in progress
are disconnected and all of the system and telephone programming
settings revert to the default settings.
■ The PC Card in the PC Card slot must be a PARTNER ACS
Backup/Restore PC Card, which can be purchased from Lucent
Technologies.
NOTE:
ACS Release 3.0 includes a PARTNER Remote Access PC Card,
which allows the user to administer the system remotely
1
and
perform backup and restore functions. The PARTNER Remote
Access PC Card is a PCMCIA card that can also be used to upgrade
previous versions of PARTNER ACS to Release 3.0.
1. Additional PARTNER Remote PC-Software required.