Filter
Top Products
Section 300-Installation Chapter 3. Cabinet Installation
DBS-2.3/9.2-300 DBS Manual - Revised April 2000 3-17
System Initialization
1. Confirm that the DBS power switch is
OFF
.
2. Plug the power cord into a dedicated 120V 15 amp AC wall outlet.
Note:
A surge protector should be installed on the power cord.
3. Set SW1 on the CPC card to RAMCLR (RAM Clear).
Figure 3-17. CPC memory clear switch
4. Turn the power switch on.
As the system loads, the bottom LED lamp on the CPC card will flash.
5. Once the bottom LED lamp on the CPC card stops flashing, set SW1 on
the CPC to RAMHOLD.
RAM HOLD
TRK1 TRK2 TRK3 EC1 EC2 EC3 EC4 EC5 EC6 EC7 EC8 EC/TRK SCC CPC AUX1 AUX2
STATUS
LED
SW 1
RAM CLR