Panasonic CPC-EX Telephone User Manual


 
Section 300-Installation Appendix A. EX 1.0 Feature Update
DBS-2.3/9.2-300 DBS Manual - Revised April 2000 Page A-13
The “*71” code will not work if FF3 (ExtPort)# 51# is set to “0”.
If set to “Analog port RING”, the large-display phone will work like an
SLT/OPX (no page announcements, no voice calls from other
extensions, etc.).
If the phone is in CF/DND (Call-Forward or Do Not Disturb), the phone
will remain in CF/DND even if the ringing device is changed via the
*71 code.
The incoming ring pattern for the analog device is the same as for the
digital key telephone (determined by the Extension Ring Pattern in FF3
(ExtPort)# 39# (0-9)#). If this address is set to “0” (determined by CO),
the analog device will automatically default to “1 second ON, 3 seconds
OFF.”
Ring Patterns Not Applicable to Analog Device.
The following ring
pattern addresses
will not
affect the analog device:
Analog Transfer Ring Pattern FF1 2# 1# 31# (0-6)#
SLT DISA Ring Pattern FF1 2# 1# 34# (0 or 1)#
Inbound Ring Pattern FF2 (Trunk)# 17# (0-9)#
Flash Interaction
. Any disconnect signal sent to the analog port must be
greater than the SLT Flash Control; otherwise the disconnect signal will be
interpreted as a flash and the call will be placed on hold.
Programming Addresses That Affect the Analog Device.
The following
addresses will control the analog device, but will not affect the digital key
telephone:
AEC Disconnect Duration FF1 2# 1# 35# (0-15)#
SLT Flash Control FF1 2# 1# 11# (0 or 1)#
SLT Onhook Flash Timer FF1 3# 14# (0-6)#
AEC Disconnect FF3 (ExtPort)# 46# (0
or 1)#
Analog Port on Large-Display Phone FF3 (ExtPort)# 51# (0
or 1)#
Data Security on Analog Port FF3 (ExtPort)# 52# (0
or 1)#
MSG (Message) Key
Description
The MSG key on the VB-44225 Large-Display Phone adds the following
functionality to the phone:
Auto-Callback.
If a callback message has been left by another
extension, you can press the MSG key to place an automatic callback to
the extension that sent the message. If more than one callback message