Filter
Top Products
Chapter 5. Peripheral Equipment
Section 300-Installation
5-8 DBS Manual - Revised April 2000 DBS-2.3/9.2-300
Background Music/Music-On-Hold
Guidelines
• A single music source can be used for both background music (BGM) and
music-on-hold (MOH), or separate music sources can be used for each
feature.
• If a single music source is used for both MOH and BGM, the music source
connects to CN5 on the Connector Panel. If separate sources are used, the
MOH source connects to CN5, and the BGM source connects to the BGM
connector on the SCC card.
• If an FM radio is connected to the BGM connector on the SCC, install it at
least 16.5 ft. (5m) away from the main cabinet. If it is too close, the
receiver may not function properly.
• The maximum input impedance of both terminals is 10k ohms. The
maximum signal level is -10 dB.
• Beginning with CPC-AII and CPC-B Version 7.0, an internal hold tone
may be selected in programming. If selected, the internal hold tone will
always be used even if a sound source is connected to MOH connector
CN5.
Installation
1. If you are using a single source for both BGM and MOH, connect the
source to CN5 on the Connector Panel. If using separate sources, connect
the MOH source to CN5 and the BGM source to the BGM connector on
the SCC card.
2. Strap the CN5 block (SCC-A) or the CN4 block (SCC-B) according to
the number of music sources used.
To route the music from ... Do this ...
A single source Short pin 3 to 2.
Separate sources Short pin 1 to 2.