Filter
Top Products
Page 24 Introduction to Your Treo™ 180 Communicator
To connect the HotSync cable:
1. Connect the travel charger cable to the short end of the Hotsync cable. Be sure to match the
sides of the connectors labeled “UP.”
2. Connect the USB HotSync cable to a USB port on your computer, or connect the Serial
HotSync cable to a Serial port on your computer.
3. Connect the long end of the HotSync cable to your communicator with the button facing up.
Note: If you are unsure about the exact location of the USB port or serial port on your computer,
refer to the manual supplied with the computer.
4. Plug the travel charger into a wall outlet.
Tip: The travel charger does not need to be plugged into a wall outlet to perform a HotSync
operation. However, if you want to use the HotSync cable to charge your Treo
communicator, you must plug the travel charger into a wall outlet.
USB cable and port
S
er
i
a
l
ca
bl
e an
d
port