Filter
Top Products
130 Using System features
Enterprise Edge Feature Programming Telephone Guide P0908510 Issue 01
Using Class of Service (COS) passwords
Class of Service passwords permit controlled access to a system’s resources both
by internal and remote users. When you enter a Class of Service password at a
telephone, the restriction filters associated with your Class of Service password
apply, rather than the normal restriction filters. Similarly, when a remote user enters
a Class of Service password on an incoming auto-answer line, the restriction filters
and remote package associated with their Class of Service password apply, rather
than the normal restriction filters and remote package. COS passwords are
programmed by your installer.
Users should memorize their COS passwords instead of writing them down.
Employees’ COS passwords should be deleted when they leave the company.
Typically, each user has a separate password. Several users can share a password or
one user can have several passwords.
Changing your Class of Service
ƒfl°
You must enter a Class of Service password each time you want to make a call that
is normally restricted on a line or telephone.
To change the restriction filters on a line or telephone:
1. Press
ƒfl°
.
2. Enter your six-digit COS password.
COS passwords allow you to define individual passwords and determine the
restriction filters, and remote package associated with each.
Tip
If you use your Enterprise Edge system from outside the office, you may have
to enter a Class of Service password to gain access to the system. See Using
your Enterprise Edge system from an external location on page 127.