Filter
Top Products
Using System features 119
P0908510 Issue 01 Enterprise Edge Feature Programming Telephone Guide
Turning Services on and off using feature codes
The master control for services is in programming. See Turning Services on and off
on page 117. Day-to-day use of Services is controlled using the following feature
codes.
To turn a Service on:
1. Enter the appropriate feature code from a control telephone.
2. Press
NEXT
to move through the schedules until the display shows the version
of the service you want to be turned on.
3. Press
OK
to select the setting, or press
QUIT
to exit the feature without making
any changes.
To turn a Service off:
1. Enter the appropriate feature code from a control telephone.
Viewing the active Services from a two-line display telephone
When a Service is active, the control telephone display reads
Services ON
.
1. Press
LIST
. The display shows the first active Service and the schedule that is
in use.
2. If there are several active Services, press
NEXT
to see them all.
3. Press
EXIT
to exit the feature.
ƒ°‡⁄
Turns on Ringing service. When used at the
direct-dial telephone, it activates the alternate
direct-dial telephone (extra-dial telephone).
ƒ£°‡⁄
Turns off Ringing service.
ƒ°‡¤
Turns on Restriction service.
ƒ£°‡¤
Turns off Restriction service.
ƒ°‡‹
Turns on Routing service.
ƒ£°‡‹
Turns off Routing service.
Do not confuse activating Normal service with canceling a Service.
Setting a Service to Normal is not the same as canceling a Service using a
feature code. If you set the Service to Normal, the normal version of a
Service overrides any automatic schedule and remains in effect until you
manually cancel it. If you cancel the Service, you return to the automatic
schedule.