Filter
Top Products
122 Using System features
Enterprise Edge Feature Programming Telephone Guide P0908510 Issue 01
You cannot forward calls to a direct-dial telephone that is outside your Enterprise
Edge system. See Making changes to Call Forward No Answer on page 25.
Changing the direct-dial telephone assignments
Your installer sets up the direct-dial telephone.
You can change which direct-dial telephone a telephone is assigned to, or assign it
no direct-dial telephone.
You need to start a Unified Manager session to program this feature. See Getting
Started on page 13 for more information.
1. Select Terminals & Sets.
2. Select a DN number.
3. Double-click Capabilities.
4. Select a Direct dial set: Set 1, Set 2, Set 3, Set 4, Set 5, or None.
Any number of telephones can be assigned to call the direct-dial telephone.
Hotline
A hotline telephone calls a preset internal or external telephone number when you
pick up the receiver (or press
©
).
Bypassing a Hotline
Press a line button, or use the Pre-Dial or Automatic Dial feature before you pick
up the receiver or press
©
on a hotline telephone. See the Telephone
Feature
Card or see Changing how you dial your calls on page 48.
Tip
The digit you dial in order to get the direct-dial telephone to ring can be
programmed by your installer.
The Enterprise Edge system cannot verify that the number you assign as an
external direct-dial telephone is valid. Check the number before assigning it
as a direct-dial telephone, and call the direct-dial telephone after you’ve
assigned it in order to test it.
Tip
Label the telephone to inform anyone using it that Hotline is active.