Filter
Top Products
44
List of AT Commands for Nokia 22
Copyright © Nokia Mobile Phones 2001. All rights reserved.
1 CLIR invocation
2 CLIR suppression
<m> shows the subscriber CLIR service status in the network:
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
7.8 +COLP Connected line identification presentation
Command Response Default
Set
+COLP=<n> 0
Read
+COLP? +COLP: <n>,<m>
Test
+COLP=? +COLP: (0,1)
The +COLP command refers to the GSM supplementary service COLP (Connected Line
Identification Presentation) that enables a calling subscriber to get the connected line identity
(COL) of the called party after setting up a mobile originated call. The command enables or
disables the presentation of the COL. It has no effect on the execution of the COLR supplementary
service in the network.
When enabled (and called subscriber allows), the +COLP: <number>,<type> intermediate result
code is returned before any +CR or V.25ter responses.
The read command gives the status of <n> and triggers an interrogation of the provision status of
the COLP service according to GSM 02.81 (given in <m>).
The test command returns the supported values.
Defined values
<n> sets/shows the result code presentation status in the Nokia 22:
0 disable
1 enable
<m> shows the subscriber COLP service status in the network:
0 COLP not provisioned
1 COLP provisioned
2 unknown (e.g. no network, etc.)
<number> string type phone number of a format specified by <type>
<type> type of address octet in integer format (refer GSM 04.08 subclause 10.5.4.7):
129 unknown/telephony
145 international/telephony