Nokia 9356900 issue 1 Telephone User Manual


 
43
List of AT Commands for Nokia 22
Copyright © Nokia Mobile Phones 2001. All rights reserved.
Defined values
<n> parameter sets/shows the result code presentation status in the Nokia 22:
0 disable
1 enable
<m> parameter shows the subscriber CLIP service status in the network:
0 CLIP not provisioned
1 CLIP provisioned
2 unknown (e.g. no network, etc.)
<number> string type phone number of a format specified by <type>
<type> type of address octet in integer format (refer to GSM 04.08 subclause
10.5.4.7):
129 unknown/telephony
145 international/telephony
7.7 +CLIR Calling line identification restriction
Command Response Default
Set
+CLIR=<n> 0
Read
+CLIR? +CLIR: <n>,<m>
Test
+CLIR=? +CLIR: (0-2)
The +CLIR command refers to the CLIR-service according to GSM 02.81 that allows a calling
subscriber to enable or disable the presentation of the CLI to the called party when originating a
call.
The set command overrides the CLIR subscription when the temporary mode is provisioned as a
default adjustment for all the following outgoing calls. This adjustment can be revoked by using the
opposite command. If this command is used by a subscriber without a provision of CLIR in the
permanent mode, the network will act according GSM 02.81.
The read command gives the default adjustment for all the outgoing calls (given in <n>) and
triggers an interrogation of the provision status of the CLIR service (given in <m>).
The test command returns the supported values.
Defined values
<n> sets the adjustment for outgoing calls:
0 the presentation indicator is used according to the subscription of the
CLIR service