Nokia 9356900 issue 1 Telephone User Manual


 
26
List of AT Commands for Nokia 22
Copyright © Nokia Mobile Phones 2001. All rights reserved.
6.1.10 S8 Comma dial modifier time
Command Response <n> values
Set
S8=<n> 0..255 (default 2)
Read
S8? <n> 000..255
The S8 command specifies the time in seconds that the DCE shall pause during the signalling of
call addressing information to the network (dialling) when a “,” (comma) dial modifier is
encountered in a dial string of the D command. The implementation is according to GSM 07.07
section 6.18.
6.1.11 S10 Automatic disconnect delay
Command Response <n> values
Set
S10=<n> 0..255 (default 100)
Read
S10? <n> 000..255
The S10 command sets the time in tenths of a second that the Nokia 22 will remain connected to
the line (off-hook) after it has indicated the absence of the received line signal. If the received line
signal is detected before the time specified in the S10 expires, the Nokia 22 remains connected to
the line and the call continues. The implementation is according to GSM 07.07 section 6.18.
6.1.12 L Monitor speaker loudness
Command
Execute
L[0]..L3
The L command is ignored. The implementation is according to GSM 07.07 section 6.18.
6.1.13 M Monitor speaker mode
Command
Execute
M[0]..M2
The M command is ignored. The implementation is according to GSM 07.07 section 6.18.
6.1.14 +DS Data compression
Command Response Default
Set
+DS=<dir>,<neg>,<P1>,<P2> 0,0,2048,20
Read
+DS? +DS: <dir>,<neg>,<P1>,<P2>
Test
+DS=? +DS: (0-3),(0,1),(512-2048),(6-32)
The +DS command controls the V.42 bis data compression function.
NOTE: The V.42 bis data compression must be supported by the network.