Filter
Top Products
MultiVOIP User Guide Mechanical Installation
97
Cabling
Cabling Procedure for MVP2410/3010
Cabling your MultiVOIP entails making the proper connections for power,
command port, phone system (T1/E1 line connected to PBX or telco office),
and Ethernet network. Figure 3-9 shows the back panel connectors and the
associated cable connections. The following procedure details the steps
necessary for cabling your MultiVOIP.
1. Connect the power cord to a live AC outlet, then connect it to the
MultiVOIP’s power receptacle shown at top right in Figure 3-9.
ETHERNETCOMMAND
DIGITAL VOICE
ETHERNETCOMMAND
10 BASET
RS232
DIGITAL VOICE
TRUNK
T1
PBX
PSTN
Telephony Connection
Network Connection
Command Port Connection
Hub
Figure 3-9. Cabling for MVP2410/3010
2. Connect the MultiVOIP to the PC (the computer that will hold the
MultiVOIP software) using the RJ-45 to DB9 (female) cable provided with
your unit. Plug the RJ-45 end of the cable into the Command port of the
MultiVOIP and connect the other end (the DB9 connector) to the PC serial
port you are using (typically COM1 or COM2). See Figure 3-9.
3. Connect a network cable to the Ethernet connector on the back of the
MultiVOIP. Connect the other end of the cable to your network.