Filter
Top Products
Overview MultiVOIP User Guide
34
MVP130 Front Panel LED Definitions
LED NAME DESCRIPTION
General Operation LEDs
Power Indicates presence of power.
Boot
After power up, the Boot LED will be on briefly while the
MultiVOIP is booting. It lights whenever the MultiVOIP is
booting or downloading a setup configuration data set.
Ethernet
SP. During normal operation, the SP LED lights to indicate
100Mbps is selected.
AC. During normal operation, the AC LED lights when
transmitting or receiving. It will flash at a rate of 50ms high
and 50ms low when active.
CL. During normal operation, the CL LED lights to indicate
a collision. It will flash at a rate of 50ms high and 50ms low
when active.
LK. During normal operation, the LK LED lights to
indicate a good link is detected.
Channel-Operation LEDs
TX
Transmit. This indicator blinks when voice packets are
being transmitted to the local area network.
RX
Receive. This indicator blinks when voice packets are
being received from the local area network.
XS
Transmit Signal. This indicator lights when the
FXS-configured channel is off-hook or the FXO-
configured channel is receiving a ring from the Telco
or PBX.
RS
Receive Signal. This indicator lights when the FXS-
configured channel is ringing or the FXO-configured
channel has taken the line off-hook.