Technical Configuration (Analog/BRI) MultiVOIP User Guide
204
When technical configuration is complete, you will need to configure the
MultiVOIP’s phonebooks (for all models) and its embedded gatekeeper
functionality, if present (for MVP-210G, -410G, and 810G only). This manual
has separate chapters describing T1 Phonebook Configuration for North-
American-influenced telephony settings and E1 Phonebook Configuration for
Euro-influenced telephony settings, as well as a separate Embedded
Gatekeeper chapter.
Local Configuration Procedure (Detailed)
You can begin the configuration process as a continuation of the MultiVOIP
software installation. You can establish your configuration or modify it at any
time by launching the MultiVOIP program from the Windows Start menu.
1. Check Power and Cabling. Be sure the MultiVOIP is turned on and
connected to the computer via the MultiVOIP’s Command Port (DB9
connector at computer’s COM port; RJ45 connector at MultiVOIP).
2. Start MultiVOIP Configuration Program. Launch the MultiVOIP
program from the Windows Start menu (from the folder location determined
during installation).