Filter
Top Products
MultiVOIP User Guide Quick Start Instructions
65
12D. To enable a call between two analog phones on the same voip, we will
set up two channels for FXS Loop Start telephony. To do so, go to the
Interface screen. Click on "FXS Loop Start" for Channel 1.
Click on "Copy Channel" and select Channel 2. Click Copy.
Click OK to acknowledge the copy. Click OK again when the main
Interface screen returns.
13. Go to Save Setup | Save and Reboot. Click OK. This will save the
parameter values that you have just entered.
The MultiVOIP’s “BOOT” LED will light up while the configuration file is
being saved and loaded into the MultiVOIP. Don’t do anything to the
MultiVOIP until the “BOOT “LED is off (a loss of power at this point could
cause the MultiVOIP unit to lose the configuration settings you have made).
14. (
For analog gatekeeper-equipped models only. These have model
numbers with a “G” suffix. For non-gatekeeper units and for
MVP2410G, skip this step.
) Connect two standard analog telephone sets to
the Channel 1 and Channel 2 FXS/FXO ports on the back of the "G" voip
unit.
At either phone, dial 65. The completion of the call to the other phone
confirms that the embedded gatekeeper of the “G” voip unit is mediating
calls.
For more information, see the “Embedded Gatekeeper” chapter of the
User
Guide
.
END OF PROCEDURE.