Filter
Top Products
Chapter 2 — Configuring the CN2G
CN2G Handheld Computer User’s Manual 45
Note: LEAP security is not supported with Microsoft security.
To enable LEAP security on your CN2G
1 Make sure you have configured the communications and
radio parameters on your CN2G.
2 Make sure you have selected Funk as your security choice.
3 From Intermec Settings, choose Communications > 802.11
Radio > Security Settings > Funk Security > Profile.
4 For Authentication, Select LEAP and then tap Save.
5 For Association, Select Open or Network EAP and then tap
Save.
6 For Encryption, Select WEP, and then tap Save.
7 Select User name, type your user name, and then tap Save.
8 Select Password prompt, choose Enter password now, and
then tap Save.
Note: You can use Prompt for password to troubleshoot
your connection to the network if you have problems.
9 Select User Password, type a user password, and then tap
Save.
10 Exit Intermec Settings.
Using Static WEP Security
The CN2G uses the Wired Equivalent Privacy (WEP) protocol
to add security to your wireless network based on the 802.11b
standard.
To use WEP security, you need:
• an access point with an 802.11b/g radio.
• a CN2G handheld computer with an 802.11b/g radio.