Filter
Top Products
Chapter 2 — Configuring the CN2G
38 CN2G Handheld Computer User’s Manual
Note: You must have the date on the CN2G set correctly
when you enable Validate Server Certificate.
If you choose TLS:
a For Validate Server Certificate, choose Enabled and tap
Save.
b You must enter a User Name and Subject Name. You can
also enter a Server Common Name if you want to increase
your level of security.
8 Exit Intermec Settings.
To enable WPA-PSK security on your CN2G with Funk security
1 Make sure you have configured the communications and
radio parameters on your CN2G.
2 Make sure you have selected Funk as your security choice.
3 Open Intermec Settings.
4 Choose Communications > 802.11 Radio > Security
Settings > Funk Security > Profile.
5 For Association, choose WPA and tap Save.
6 For Authentication, choose None and tap Save.
7 For Pre-Shared Key, enter the pre-shared key or the
passphrase.
The pre-shared key must be a value of 32 hex pairs preceded
by 0x for a total of 66 characters. The value must match the
key value on the access point. The passphrase must be from 8
to 63 characters. After you enter a passphrase, the CN2G
internally converts it to a pre-shared key.
This value must match the passphrase on the authenticator.
8 Exit Intermec Settings.