Filter
Top Products
Installation Page 89 of 174
M3900 Series Meridian Digital Telephones Description, Installation and Administration
To change the telephone angle:
1 Move the top of the footstand away from the telephone base (it has a
snap connection).
2 Place the footstand in the desired position and snap the top of the
footstand back into place.
To wall mount the telephone
The telephone wall mount bracket kit contains a one piece wall mount plate
to attach the telephone to the wall.
To wall mount the telephone:
1 Place the wall mount bracket against the wall and mark the spot to
insert the screws.
Note: M3901 and M3902 have built-in wall mount brackets.
2 Screw the five screws in and leave about 3 1/2 mm (1/8 inch) between
the head of the screw and the wall.
3 Remove the footstand from the telephone by sliding the footstand
down (using the plastic hinges) about 7 mm (1/4 inch).
4 Swing the footstand away from the telephone base and remove from
the telephone.
5 Attach the wall mount bracket onto the back of the telephone by
placing the telephone at the top edge of the wall mount bracket and
sliding the telephone into place.
6 Mount the wall mount bracket, attached to the telephone onto the
screws located on the wall.
Accessory Connection Module (ACM)
To install the ACM:
1 Disconnect the line cord from the telephone base before installing the
ACM.
2 Slide the footstand down (using the plastic hinges)about 7 mm (1/4in.)
and swing the footstand away from the telephone base.
3 Snap the ACM into the rectangular opening on the back of the
telephone.
4 Connect the ACM cable to the back of the telephone.