Filter
Top Products
Appendix A: Flash Download procedure Page 161 of 174
M3900 Series Meridian Digital Telephones Description, Installation and Administration
Install PSDL file on Core/Net 1
1 Place the CP PII Install disk into the MMDU floppy drive of Core 1.
2 Install the CD-ROM into the MMDU CD drive of Core 1:
a. Press the button on the CD-ROM drive to open the CD-ROM disk
holder.
b. Place the CD-ROM disk into the holder with the disk label showing.
c. Use the four tabs to secure the CD-ROM drive.
d. Press the button again to close the CD-ROM disk holder (do
not push the holder in by hand).
3 Press the manual RESET button on the Core 1 CP II card
faceplate.
4 Before the install runs, the system validates hard disk partitioning.
This takes approximately five minutes. The screen displays:
Testing partition 0
5 At the terminal, press <cr> to start the software installation.
0 percent done… 1 percent done… 99 percent done… 100 percent done
Testing partition 1
0 percent done… 1 percent done… 99 percent done… 100 percent done
Testing partition 2
0 percent done… 1 percent done… 99 percent done… 100 percent done
Disk physical checking is completed!
There are 3 partitions in disk 0:
The size of partition 0 ix XX MB
The size of partition 1 ix XX MB
The size of partition 2 ix XX MB
Disk partitions and sectors checking is completed!