Filter
Top Products
Page 148 of 174 Appendix A: Flash Download procedure
553-3001-216 Standard 5.00 January 2002
Test Core/Net 1
1 Test Call Processing. This includes, but is not limited to the following:
a. Check for dial tone.
b. Make internal, external, and network calls.
c. Check attendant console activity.
d. Check DID trunks.
e. Check any auxiliary processors.
Note: From this point forward you will be upgrading Core/Net 0.
Install software on Core/Net 0
1 Move the CPSI port cable from J25 on Core/Net 1 to J25 on Core/Net 0.
2 Set the IODU/C faceplate switch to ENB.
3 Place the CP Install disk that corresponds with the installed CP card type
into the IODU/C in Core/Net 0.
a. Press the button on the CD-ROM drive to open the CD-ROM disk
holder.
b. Place the CD-ROM disk into the holder with the disk label showing.
c. Use the four tabs to secure the CD-ROM drive.
d. Press the button again to close the CD-ROM disk holder (do not
push the holder in by hand).
4 Press the MAN RST button on the CP card in Core/Net 0 to reboot the
system and start the Software Installation Tool. (The terminal displays
SYSLOAD messages during file loading. When SYSLOAD is
completed, the NT logo appears.)
5 When the NT logo appears, press <CR> to continue.
6 When the Main Menu appears, select the following options in sequence:
<u> to Install menu