Filter
Top Products
XTP SR HDMI Scaling Receiver • Reference Information 46
Installing Firmware with Firmware Loader
1. Connect the host device to the front panel USB port.
2. Open Firmware Loader and establish a connection between the computer and the
device. The Add Device... dialog box opens.
Figure 36. Add Device... Dialog Box
3. From the Device Name drop-down list, select XTP SR HDMI.
4. From the Connection Method drop-down list, select the method of connection.
5. Depending on the connection method, additional options appear. Make the appropriate
selections for the current connection method.
6. Click the Connect button.
7. Click the Browse button in the New File Firmware (Optional) panel. The Open
dialog box opens.
8. In the Open dialog box, navigate to the location of the new firmware file, select the
desired file.
ATTENTION:
• Valid firmware files must have the file extension .S19. A file with any other
extension is not a firmware upgrade for this device and could cause the device
to stop functioning.
• Les fichiers firmware valides doivent contenir l’extension fichier S19. Un fichier
avec n’importe quelle autre extension n’est pas une mise à jour de firmware
pour cet appareil et l’appareil pourrait arrêter de fonctionner.
9. Click the Open button. The Browse dialog box closes.
10. Click the Add button. The Add Device... dialog box closes and the device and
firmware are listed in the Firmware Loader main window.
11. Click the Begin button to start the upload process.
12. Close Firmware Loader when the Remaining Time field shows 00.00.00, the
Progress column shows 100%, and the Status field shows completed.