Filter
Top Products
XTP SR HDMI Scaling Receiver • Operation 17
Input Configuration Submenu
The Input Configuration submenu displays the total pixels and horizontal and vertical
active pixels of the input signal.
Figure 13. Input Configuration Submenu
Total pixels — Displays the total pixels of the input signal. This is not configurable.
Active — Displays the active horizontal (H) pixels and vertical (V) lines of the input signal.
These are not configurable.
Output Configuration Submenu
The Output Configuration submenu is used to configure of the output resolution and
refresh rate. Output format and color bit depth settings are not configurable from the OSD.
To configure either setting, use SIS commands (see Output Configuration Commands on
page 25) or use the XTP System Configuration Software (see Input/Output tab on
page 35).
Figure 14. Output Configuration Submenu