XTP SR HDMI Scaling Receiver • Installation 5
ATTENTION:
• Do not connect this connector to a computer data or telecommunications
network.
• Ne connectez pas ce port à des données informatiques ou à un réseau de
télécommunications.
• XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see Remote power on
page 11).
• XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l’alimentation XTP à distance ne peut être routée en
extérieur (voir Remote power à la page 11).
B
LAN connector — Connect a control device or device to be controlled to the RJ-45
connector labeled LAN for 10/100Base-T Ethernet communication through this
pass-through port. LEDs on the connector indicate link and activity status.
C
RS-232 Over XTP port — To pass bidirectional serial or other control signals
between XTP-compatible devices, connect a control device to the 5-pole
captive screw connector. The port includes only the 3 poles labeled “RS-232.”
IR Over XTP port — To transmit and receive IR signals (up to 40 kHz),
connect a control device to the 5-pole captive screw connector. This port
includes only the 2 poles labeled “IR” and shares the ground pole with the
RS-232 port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see RS-232 and IR
Over XTP Communication on page 9 for wiring details).
D
HDMI output connector — Connect a digital video display to the female HDMI
connector (see Rear Panel HDMI Audio Switch on page 13 to mute or unmute
embedded audio output). It can accept HDMI, DVI (with an appropriate adapter), or
DisplayPort video signals.
NOTES:
• The maximum cable length is 15 feet.
• Use Extron LockIt lacing brackets to secure HDMI connectors to the device
(see HDMI Connection on page 6).
E
Analog audio output connector — Connect a balanced or unbalanced, stereo or
mono audio output device to the 3.5 mm, 5-pole captive screw connector for 2-channel
stereo analog audio output (see figure 3 for wiring details).
NOTE: If the device is receiving 2-channel LPCM embedded audio on the HDMI
input signal, it is extracted and converted to a stereo analog signal.
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
Slee
ves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Figure 3. Audio Output Wiring
ATTENTION:
• For unbalanced audio, connect the sleeves to the contact ground. Do not
connect the sleeves to the negative (-) contacts.
• Pour l’audio asymétrique, connectez les manchons au contact au sol. Ne pas
connecter les manchons aux contacts négatifs (–).
IR
Tx Rx G Tx Rx
RS-232
IR
Tx Rx G Tx Rx
RS-232