Filter
Top Products
XTP SR HDMI Scaling Receiver • SIS Configuration and Control 25
Command ASCII Command
(host to XTP)
Response
(XTP to host)
Additional Description
Output Configuration Commands
Output scaler rate
Set output rate
EX3$RATE} RateX3$]
Select output resolution and refresh rate.
View output rate
ERATE} RateX3$]
Show selected output rate.
HDMI output format
Set HDMI output format
EX1)VTPO} VtpoX1)]
Set the output color space and format.
View HDMI output
format
EVTPO} VtpoX1)]
View the output color space and format.
Test pattern
NOTE: See figure 16 on page 19 for examples of the available test patterns.
Set pattern
X1!J TstX1!] Set the test pattern to X1!.
View test pattern
J
Tst
X1!]
View the current test pattern.
Video bit depth
Set video bit depth
EVX1@BITD} BitdVX1@]
Set the video bit depth.
View video bit depth
EVBITD} BitdVX1@]
View the video bit depth.
Freeze
Enable
1F
Frz1
]
Freeze the selected input.
Disable
0F
Frz0
]
Unfreeze the selected input.
View freeze status
F
Frz
X!]
View the freeze status.
NOTES:
X! = Enable or disable
0 = disabled or off (default for freeze command)
1 = enabled or on
X1) = HDMI output format
0 = auto (default)
1 = DVI RGB 444
2 = HDMI RGB 444 “Full”
3 = HDMI RGB 444 “Limited”
4 = HDMI YUV 444 “Full”
5 = HDMI YUV 444 “Limited”
6 = HDMI YUV 422 “Full”
7 = HDMI YUV 422 “Limited”
X1! = Test pattern
0 = off (default)
1 = crop
2 = alternating pixels
3 = crosshatch
4 = colorbars
5 = greyscale
X1@ = Video bit depth
0 = auto (default)
1 = 8 bit
X3$ = Output scaler rate and refresh rate
See the table on page 22.