Filter
Top Products
XTP SR HDMI Scaling Receiver • Installation 11
Remote power
The XTP SR HDMI can be powered remotely through an XTP Power Injector or through an
XTP matrix switcher.
ATTENTION:
• XTP remote power is intended for indoor use only. No part of the network that uses
XTP remote power should be routed outdoors.
• XTP à distance est destiné à une utilisation en intérieur seulement. Aucune partie
du réseau qui utilise l’alimentation XTP à distance ne peut être routée en extérieur.
Power injector
To power the XTP SR HDMI remotely with an XTP Power Injector, power one device locally
(see Local power on page 10) and connect an XTP Power Injector to the XTP cable
run along the XTP ports (see the XTP Power Injector User Guide for more installation
information).
POWER
12V
HDMI
0.7A MAX
Rx GTx
RS-232 IR
RxTx
−+
−+
LR
LOOP THRU
RESET
AUDIO
OFF
ON
AUDIO
XTP T HDMI
LAN
SIG LINK
XTP OUT
INPUTS
OVER XTP
LAN
SIG LINK
XTP IN
POWER
12V
HDMI
1A MAX
RxGTx
RS-232 IR
RxTx
−+−+
LR
1
2
OVER XTP
AUDIO
OFF
ON
S/PDIF
RESET
RS-232
TxRxG
REMOTERELAYS
OUTPUTS
AUDIO
XTP
PWR
XTP PWR
100-240V
50/60 Hz
---A MAX
Power
Extron
XTP SR HDMI
XTP Receiver
Extron
XTP T HDMI
XTP Transmitter
Extron
XTP PI 100
XTP Power
Injector
CAT 5-Type
Cable
REMOTE
POWER
12V Local Power
Supply
Figure 8. Typical Point-to-Point Application with Remote Power
NOTE: The power injector provides remote power up to 330 feet with a shielded twisted
pair cable with 24 AWG wire.
Direct power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to
connected XTP endpoints (see the XTP matrix switcher user guide for more details). To
manage available power from the XTP matrix switcher, use the XTP System Configuration
Software with the matrix switcher.