Filter
Top Products
XTP SR HDMI Scaling Receiver • XTP System Configuration Software 41
Screen Saver panel
The Screen Saver panel on the General screen is used to enable or disable a screen
saver. When enabled, the output sync is disabled after a specified amount of time.
5
Never — Click the Never radio
button to disable the screen saver
setting.
6
Duration — Enter a value in the
After: field, or click the Up and
Down arrows to specify a duration
of inactivity before a screen saver is
activated. The duration is set in minutes.
HDCP Mode panel
The HDCP Mode panel on the General screen is used to set HDCP encryption of the output
signal.
7
Follow — Click the Follow radio
button to set the HDCP encryption
of the output signal to follow the
input signal setting.
8
Always Encrypt Output — Click
the Always Encrypt Output radio
button to always encrypt the output
regardless of the encryption status of the input signal.
Switch Mute panel
The Switch Mute panel on the General screen is used to enable or disable mutes during
switching.
9
Basic mute — Select the Enable
check box in the Basic Mute panel
to mute the output during switching.
If enabled, enter a value in the
associated Duration: field, or click
the Up and Down arrows to specify
a mute duration between switching.
The duration is set in 0.5 second increments.
-
Advanced mute — Select the
Enable check box in the Advanced
Mute
panel to add an additional
mute to help compensate for
switching between different input
resolutions.
If enabled, enter a value in the
associated Duration: field, or click
the Up and Down arrows to specify a duration of the additional mute. The duration is set
in 0.5 second increments.
Factory Reset
Click the Factory Reset button (see figure 32,
=
) to reset the receiver to factory settings
(except for firmware).
NOTE: This is the same as the EZXXX SIS command (see the Factory defaults SIS
command on page 28).