Filter
Top Products
Operational Features
41-001160-00, Release 2.1, Rev 04 5-157
Configuring Operational Features
Operational IP Phone Features
Configuring a Park/Pickup Key Using Aastra Web UI
On the 57i/57i CT, you configure a Park and/or Pickup key at
Operation->Softkeys and XML. You enter a key label, and value for a specific
line on the phone. The default state of the Park configuration is "connected". The
default state of the Pickup configuration is "idle, outgoing".
The 57i CT handsets use the park/pickup configuration enabled at
Operation->Handset Keys in the Aastra Web UI. If Park or Pickup are enabled
on more than one line on the base unit, the 57i handset uses the first
programmable configuration.
For example, if line 1 and line 6 are configured for park, the 57i CT handset uses
the configuration set for line 1 to park a call.
On the 53i, you configure a Park and/or Pickup key at
Operation->Programmable Keys, and then enter the appropriate value and line.
Park/Pickup Call Server Configuration Values
*Leave "value" fields blank to disable the park and pickup feature.
Use the following procedure to configure the Park/Pickup call feature using the
programmable configuration method and the Aastra Web UI.
Note: Applicable values depend on the server in your network (Asterisk,
BroadWorks, Sylantro, ININ PBX. See the table below for applicable
values.
Server Park Values* Pickup Values*
Aasterisk 70 70
Sylantro *98 *99
BroadWorks *68 *88
ININ PBX callpark pickup