Filter
Top Products
Global SIP Settings
4-70 41-001160-00, Release 2.1, Rev 04
IP Phone Administrator Guide
Configuring the IP Phones
Configuring RTP Features
Use the following procedures to configure the RTP features on the IP phone.
Configuration Files
For specific parameters you can set for RTP features in the configuration files, see Appendix A, the section,
“RTP, Codec, DTMF Global Settings” on page A-77.
IP Phone UI
Step Action
1 Press on the phone to enter the Options List.
2Select Administrator Menu.
3 Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4Select SIP Settings.
5 Select RTP Port Base to change the RTP port base setting. Default is 3000.
6 Press Done (2 times) to save the change.
Note: The session prompts you to restart the IP phone to apply the configuration settings
7Select Restart.