Filter
Top Products
Network Settings
4-12 41-001160-00, Release 2.1, Rev 04
IP Phone Administrator Guide
Configuring the IP Phones
Full-Duplex (10Mbps or 100Mbps)
Full-duplex data transmission means that data can be transmitted in both
directions on a signal carrier at the same time. For example, on a LAN with a
technology that has full-duplex transmission, one device can be sending data on
the line while another device is receiving data. Full-duplex transmission implies a
bidirectional line (one that can move data in both directions). On the IP phones,
you can set the full-duplex transmission to transmit in 10Mbps or in 100Mbps.
Configuring the LAN Port and PC Port
You can configure the Ethernet port transmission method to use on the IP phones
using the configuration files, the IP Phone UI, or the Aastra Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Network
Settings” on page A-6.
IP Phone UI
Step Action
1 Press on the phone to enter the Options List.
2Select Administrator Menu.
3 Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4Select Network Settings.
5Select Ethernet.
6Select LAN Port Link.