Filter
Top Products
Toll Restriction
Program 40 – Station CO Line Access
4-4 Strata DK Programming 5/00
Program 40 – Station CO Line Access
Processor Type: DK14, DK40i, all RCTUs and BCUs
Program Type: Toll Restriction
Initialized Default: All LEDs On for all CO lines (all stations can access all lines)
✱ ✱ ✱ ✱ 6SNU +ROG 6SNU +ROG 6SNU +ROG 6SNU +ROG
Processor Type [PDN] Port Range
DISA Port
(R3.X)
Processor Type [PDN] Port Range
DISA Port
(R3.X)
DK14 000~009 010 B1CU 000~055 089
DK40i 000~027 035 B2CAU/BU 000~011 249
RCTUA 000~031 039 B3CAU/BU 000~191 249
RCTUBA/BB 000~079 089 B5CAU/BU 000~335 344
RCTUC/D 000~239 249
RCTUE/F 000~335 344
Port Number
Program 16
Line Group
Number
900~916 00~16
CO Line LED
Port
20
19
18
17
16
15
14
13
12
11
10
09
08
07
06
05
04
03
02
01
LED Buttons = CO Lines
Light LEDs for the port(s) that are
allowed access.
SELECT = Station Logical Port Numbers
To add a port range, enter XXX✱XXX (low port ✱ high port).
Press
6FUROO to advance or 3DJH to go back.
To turn all CO LEDs On or Off, after the port number and is entered, press
Vol▲ (all LEDs On) or Vol▼ (all LEDs Off).
To check a particular CO line, after the port number is entered, press
0RGH and enter the CO line number, then press to display
and advance.
For R4.3 and higher: If a Tie line is assigned in Program 16 for Toll Restriction and LCR
on tandem calls, assign a class of service in this program. Program ports 900~916 to
match the Tie line group numbers 01~16, respectively.